![]() Existing IKE/IPSec SAs clearedĪlso when we transfer files to the customer side,the connection times out and hangs randomlyĪlso when i do "show security ike security-association" and "show security ipsec security-association" i dont see that particular vpn listed in the output however once i do ping to the customer side ,the vpn comes up and i can see it on the output of those show commands. Local-ip: 172.17.30.2, gateway name: gw-efis, vp n name: ike-vpn-efis, tunnel-id: 131075, local tunnel-if: st0.12, remote tunnel- ip: Not-Available, Local IKE-ID:, Remote IKE-ID: 161.156.130.175, AAA user name: Not-Applicable, VR id: 7, Traffic-selector:, Traffic-selector local ID: i pv4_subnet(any:0,=10.15.29.0/29), Traffic-selector remote ID: ipv4_subnet( any:0,=10.75.53.0/26), SA Type: Static, Reason: DPD detected peer as down. 156.130.175 is dead, so dropping the tunnel Oct 26 16:30:57 sn-dx-node0 kmd: KMD_DPD_PEER_DOWN: DPD detected peer 161. ![]() A device performs this verification by sending encrypted IKE Phase 1 notification payloads (R-U-THERE) to peers and waits for DPD. DPD is a method used by devices to verify the current existence and availability of IPsec peer devices. įrom the beginning i was receiving this alert in the log message: This article provides information on Dead Peer Detection (DPD) and its behavior on SRX devices. The issue i`m having is that i configured ipsec vpn ,in our side we use Juniper srx ,the customer side are using Citrix netscaler. Free, Actual and Latest Practice Test for those who are preparing for. ![]() Does anyone has a guide of ipsec configuration between juniper srx and Citrix Netscaler?(i googled but i couldn`t find anything)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |